Inline Monitor's Led Display; Automatic Mode - Raritan Dominion Px User Manual

Inline Monitor's LED Display

8. Locate the outlet whose CH number is identical to that of the inlet
where the power cord was just installed. For example, if the inlet
where you installed a power cord is labeled CH1, now you must locate
the outlet labeled CH1 for cord installation.
9. Slightly loosen the dome nut on the identically-numbered outlet.
10. Repeat Steps 3 to 7 to wire a power cord on this outlet.
11. Verify that the L1 wire color of the inlet is the same as that of the
identically-numbered outlet. Then verify colors of the other wires in the
same way.
12. Repeat Steps 2 to 11 to wire power cords on the remaining pairs of
inlets and outlets.
13. Install back the top cover.
Now you can connect any inlet's power cord to a branch circuit, and any
outlet's power cord to a device.
Note: In North America and Europe, the rating of the branch circuit can be
125% greater than the inlet's rating. For example, the branch circuit rating
for PX-3370 can be up to 40A.
The LED display of an inline monitor is the same as a regular Dominion PX
model. See LED Display

Automatic Mode

Unlike regular Dominion PX models, the inline monitor's LED display only
cycles through the current readings of each outlet in the Automatic Mode.
(on page 33).
Chapter 8: Inline Monitors
197