Communication Diagnostics - Honeywell LYNX Touch L5200 Series Programming Manual

Communications Diagnostics
Note: For additional information regarding these fields, refer to the LYNX Touch Installation and Setup Guide P/N 800-16082 or
higher.
Comm. Diagnostics
Communication Status - Provides a status of the IP or Cellular communications paths and performs a self-test of the
Ethernet Information - Displays IP information if the IP Communication Path is enabled.
GSM Information - Displays GSM information if the GSM communication path is enabled and the device is registered.
(2G only, always available in 3G/4G)
Pri Sync Code: (3G/4G only)
If the GSM is not registered the following may be displayed:
Cell Registration: SIM Not Active
Cell Registration: Not Registered
Communication ID Numbers- Displays programmed SIM card information for the installed communication module.
* If applicable

Communication Diagnostics

Choose from the following options (depending upon the Communication Module that is
installed:
Communication
Status
Communication
ID Numbers
WiFi Location
advanced encryption standard (AES) algorithm.
Message
GSM OR IP:
Encryption:
AlarmNet Registration:
Message
Physical Link:
DHCP:
NIC IP Address:
Subnet Mask:
Gateway IP Address:
DNS Server IP Address:
Message
Cell Registration:
Primary RSSI:
GPRS:
Country:
Network:
LAC:
Cell:
Base Station: (2G only)
Channel:
Second Site RSSI:
Searching for Coverage!
SIM Error!
Message
MAC:
MAC CRC:
SCID:
IMEI:
WiFi*
WiFi Ver*
Ethernet GSM
Information Information
Test Setup
Communication Communication
WiFi Status Configure
WiFi
Function
Displays Network Connectivity status
Displays result of encryption test (Pass or Fail)
Displays Account Registration status
Function
Confirms physical link connection and speed
Displays status of server
Displays the communication device's assigned IP address
Displays the 32-bit address mask used to indicate the portion (bits) of the
IP address that is being used for the subnet address
Displays the IP address assigned to the Gateway
Displays the IP address assigned to the DNS server
Function
Displays registration status
Displays primary site RSSI signal strength (1 to 5 stars)
Displays availability of GPRS service.
Displays country code
Displays network code
Displays local area code
Displays base station ID (4-digit in 2G or 6-digit in 3G/4G)
Displays Base Station Antenna Sector
Displays primary sync code
Displays control in use
Displays presence of Secondary site RSSI level availability
Searching for cell network
No SIM card present of SIM card faulty
SIM is not activated
Not registered with the cell network
Function
Displays MAC address
Displays MAC CRC number
Displays SIM card identification number
Displays communication module identity number
Displays physical address of the WiFi module
Displays WiFi Module software version
- 18 -