Oki MC-860 / CX2633MFP Service & Troubleshooting Manual page 38

UTMP: Fuser motor standard speed correction parameter (Fuser target temperature) [unit: DEC]
REG: Hopping motor standard speed timer value (I/O setting value) [unit: HEX]
EXT: Fuser motor standard speed timer value (I/O setting value) [unit: HEX]
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
KID, YID, MID and CID are the standard speed timer values for each ID motor (I/O setting value) [unit: HEX]
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
BELT: Belt motor standard speed timer value (I/O setting value) [unit: HEX]
FRM: [***] = Frame thermistor read-out AD value [unit: HEX] ( xxx ) = Frame temperature [unit: °C]
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
DB: Develop voltage setup table ID number [unit: HEX]
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
TR1: Transfer voltage parameter VTR1 table ID number [unit: HEX]
TR2: Transfer voltage parameter VTR2 table ID number [unit: HEX]
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
The message is displayed but does not function.
Pressing the switches the display. When the
(2) key
the test. (Screen returns to the item 1 condition.)
key is pressed, the screen exits
(#)
key is pressed, the screen exits
(#)
key is pressed, the screen exits
(#)
key is pressed, the screen exits
(#)
key is pressed, the screen exits
(#)
key is pressed, the screen exits
(#)
38