Power Management Setup - ECS GF7100PVT-M User Manual

Parallel Port Mode (ECP)
Use this item to set the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or EPP &
ECP.
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
USB Controller (Enabled)
This item enables the USB controller. Leave this at the default "Enabled" if you want
to connect USB devices to your computer.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
ACPI Suspend Type
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume By PCI/PCI-E/Lan PME
Resume By USB (S3)
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resume On Ring
Resume on RTC Alarm
: Move Enter : Select
F1:General Help
Introducing the Motherboard
Power Management Setup
S3 (STR)
Instant Off
Power Off
Select the ACPI state
Disabled
used for System Sus-
Disabled
pend.
Disabled
Disabled
Disabled
Disabled
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Help Item
37