Integrated Peripherals - ECS GF7100PVT-M User Manual

36

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Onboard IDE Controller
OnChip S-ATA Controller
SATA Mode Select
Onboard Audio Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Serial Port1 Mode
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
USB Controller
Legacy USB Support
OnBoard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
Onboard S-ATA Controller (Enabled)
This item allows you to enable or disable the onboard SATA controller.
SATA Mode select (SATA Mode)
Use this item to select the mode of the Serial ATA.
Onboard AUDIO Function (Auto)
Use this item to enable or disable the onboard audio device.
OnBoard LAN Function (Auto)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3FB/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Serial Port1 Mode (Normal)
If Serial Port1 Address is not disabled, it allows you to set the Serial Port1 Mode.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Integrated Peripherals
Enabled
Enabled
SATA Mode
Enabled
Enabled
Disabled
3FB/IRQ4
Normal
378
ECP
DMA3
IRQ7
Enabled
Enabled
: Move Enter : Select
+/-/: Value F10: Save ESC: Exit
F1:General Help F9: Optimized Defaults
Introducing the Motherboard
Help Item
DISABLED: disables the
integrated IDE Controller.
Enabled: enables the inte-
grated IDE Controller.