Advanced Setup - ECS GF7100PVT-M User Manual

32

Advanced Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Thermal Management
TM Status
Limit CPUID MaxVal
Enhanced Halt (C1E)
Intel XD Bit
Intel EIST
Intel Virtualization Technol
Quick Power on Self Test
Boot Up Numlock Status
APIC Mode
1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Removable Drives
CD/DVD Drives
Boot Other Device
Thermal Management (Enabled)
This item displays CPU's temperature and enables you to set a safe temperature to
Prescott CPU.
• TM Status (TM1/TM2): This item displays CPU Monitor status.
Limit CPUID MaxVal (Disabled)
Use this item to enable or disable the Max CPU ID value limit. When supports
Prescott and LGA775 CPUs, enables this to prevent the system from "rebooting"
when trying to install Windows NT 4.0.
Enhanced Halt (C1E) (Enabled)
This item enables or disables enhanced halt.
Intel XD Bit (Disabled)
This item allows users to enable or disable the Intel XD bit.
Intel EIST (Enabled)
This item allows users to enbale or disable the EIST(Enhanced Intel SpeedStep
Technology) function. This item shows only if the CPU supports EIST.
Intel Virtualization Technol (Enabled)
When enabled, a VMM can utilize the additional hardware capabilities provided by
Vandor pool Technology.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Advanced Setup
Enabled
TM1/TM2
Disabled
Enabled
Disabled
Enabled
Enabled
Enabled
On
Enabled
ST31660812AS
PIONEER DVD-RW DVR-
1st FLOPPY DRIVE
Press Enter
Press Enter
Press Enter
Yes
: Move Enter : Select +/-/: Value
F1:General Help
F9: Optimized Defaults
Introducing the Motherboard
Help Item
For the processorites
CPUID belows 0F41h.
TM2 only can be enable
under below setting.
1. Freq.>=3.6GHz FSB800
2. Freq.>=2.8GHz FSB533
F10: Save ESC: Exit