Merlin MT60 Installation And Operating Instructions Manual page 14

26
INSTALL DOOR CONTROL (OPTIONAL)
Locate door control where the garage door is visible, away from door and door hardware and out of the
reach of children. Mount at least 1.5m (5 feet) above the floor
Serious personal injury from a moving garage door may result from misuse of opener. Do not allow
children to operate the door control or transmitter.
Permanently fasten the caution label permanently to the wall near the door control as a reminder of safe operating
procedures.
There are 2 terminals (1) on the back of the door control (2). Strip about 6mm (1/4") of insulation from bell wire (4). Separate
wires enough to connect the white/red wire to RED terminal screw 1 and the white wire to WHT terminal screw 2.
Fasten the door control to an inside garage wall with sheet metal screws (3) provided. Drill 4mm (5/32") holes and use
anchors (6) if installing into plasterboard wall. A convenient place is beside the service door and out of reach of children.
Run the bell wire up the wall and across the ceiling to the garage door opener. Use insulated staples (5) to secure wire. The
receiver quick connect terminals are located behind the light lens of the opener. Connect the bell wire to the terminals as
follows: white/red to red (1) and white to white (2).
Operation of the Door Control
Press to open or close the door. Press again to stop the door while moving.
3
2
1
RED WHT
4
4
3
1
2
4
3
14
6mm
2
1
3
6
5