Panasonic PV-VS4821-K Operating Instructions Manual page 15

*Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
If displayed time is incorrect...
If your area observes DST (daylight saving time), but the time is incorrect;
do "Time Zone Adjust" steps on page 17.
Or, if you use Cable Box and receive more than one PBS station,
try auto clock set again entering the one you have not tried yet.
(Go to "Clock" on page 16.)
VCR C / A CLOCK CH
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
To setup VCR in case a Cable Box or DSS Receiver was
installed or replaced.
a
VCR C / A CLOCK CH
REPEAT PLAY :OFF
T I ME STAMP :ON
REMOTE WARNING :ON
AUTO SHUT- OFF :ON
S-VHS ET :OFF
IDIOMA/LANGUE : ENGLISH
VCR' S OUTPUT CH :3
SELECT :
EXIT : ACT I ON
c
VCR C / A CLOCK CHANNEL
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
WEAK SIGNAL DISPLAY : OFF
CABLE/DSS BOX SET UP
VCR Plus+ CH SET UP
SELECT : SET :
EXIT : ACT I ON
d
VCR C / A CLOCK CHANNEL
SELECT CONNECTION
VCR TV
CABLE / DSS BOX VCR TV
VCR CABLE / DSS BOX TV
SELECT : SET :
EXIT : ACT I ON
Note
• Auto clock set will be performed when VCR is turned off the first time each day.
Therefore, Cable Box must be left on.
If "AUTO CLOCK SET IS INCOMPLETE" appears
on-screen...
Auto clock set data is not available in your area.
Press ACTION to display Manual Clock Set screen,
and then go to step 6 (case 2) on page 11.
a Press ACTION to display MENU.
b Press to select CHANNEL.
c Press to select "CABLE/ DSS BOX SET UP,"
then press .
d Press to select "CABLE/ DSS BOX
TV," then press to set.
e Continue with steps 5 ~ 9 on pages 13, 14.
VCR
15