Weller WD1 Operating Instructions Manual page 7

2 sec.
III (EXIT)
6 6 . . 1 1 S S p p e e c c i i a a l l F F u u n n c c t t i i o o n n s s M M e e n n u u 1 1
If the U U P P and D D O O W W N N Scroll Keys are depressed simulta-
neously, after approximately 2 seconds, the menu
selection for the Special Functions is activated and - - I I - -
appears in the display. Release the Scroll Keys.
M M e e n n u u s s e e l l e e c c t t i i o o n n
The following settings are possible:
OFFSET, STANDBY, WINDOW (temperature settings); SET-
BACK, OFF (time settings); Lock function (On/Off);
Temperature scale ( °F /°C ).
Radio Buttons I I and I I I I are used for menu item selection.
Radio Button I I I I I I is used to exit the menu.
R R e e s s e e t t t t i i n n g g t t h h e e S S t t a a t t i i o o n n t t o o F F a a c c t t o o r r y y S S e e t t t t i i n n g g s s : :
Depress and hold Radio Button I I I I I I . Then depress the U U P P
and D D O O W W N N Scroll Keys at the same time. "F F S S E E ",
"Factory Setting Enabled" appears in the display. The
soldering station is now reset to its factory default set-
tings.
4 sec.
-1- -2-
M M e e n n u u 1 1
E E x x i i t t
I I
S S T T A A N N D D B B Y Y
O O F F F F
O O F F F F S S E E T T
S S E E T T B B A A C C K K
W W I I N N D D O O W W
° ° C C / / ° ° F F
6 6 . . 1 1 . . 1 1 S S t t a a n n d d b b y y T T e e m m p p e e r r a a t t u u r r e e
When the Setback time has elapsed, the "Set" tempera-
ture is decreased automatically to the Standby value.
The "Read" temperature is displayed (flashing) and
"S S T T A A N N D D B B Y Y " appears in the display. The Standby tem-
perature can be set in the range ( 200 - 600°F/100 -
300°C ).
Adjust the Standby temperature with the U U P P or D D O O W W N N
Scroll Keys.
Switch to previous menu item with Radio Button I I .
Switch to next menu item with Radio Button I I I I .
6 6 . . 1 1 . . 2 2 A A u u t t o o O O f f f f T T i i m m e e ( ( " " O O F F F F " " ) )
When the soldering tool is not in use, it is automatically
switched off after the "OFF" time has elapsed. The Auto
Off time can be set from 0 – 999 minutes. With a setting
of "0 min", the Auto Off function is disabled. Auto Off is
carried out independently of the Setback function. The
"Read" temperature is displayed (flashing) and may be
monitored as a decreasing heat indicator; "O O F F F F "
appears in the display. Below 122°F ( 50°C ), a flashing
dash appears in the center of the display.
E E n n g g l l i i s s h h
I I I I I I I I I I E E X X I I T T
5 5