Slideout Room Retraction (With Power Lift Bed); Slideout Room Keylock; Slideout Room Operation - Electric - Winnebago Journey Service Manual

4. Repeat steps 1-3 for the rearward end of the
retracted passenger side slideout room.
• During vehicle stops, check and retighten as
necessary.
SLIDEOUT ROOM
RETRACTION (WITH POWER
LIFT BED)
-If Equipped
Your coach may be equipped with a power
lift/lower mechanism that raises and lowers the
head of your bed to best suit your comfort needs.
This power lift/lower mechanism is equipped
with an interlock feature, which will not allow
you to retract the bedroom slideout unless the bed
is in the fully upright position.
NOTICE
Bed must be in the fully upright (vertical)
position to fully retract slideroom.
Further Information
For further power bed operating instructions,
refer to Section 9 - Furniture and Softgoods in
this manual.

SLIDEOUT ROOM KEYLOCK

–If Equipped
A master Slideout Room Keylock is located
near the power switch for the front slideout room.
This keylock must be turned ON to provide
power to the slideout control switches.
SLIDEOUT ROOMS AND LEVELING
Slideout Room Keylock
SLIDEOUT ROOM OPERATION
– ELECTRIC
WARNING
Your motorhome may have more than
one slideout room. Understand which
switch operates which slideout room prior
to operation. Make sure all slideout rooms
are clear of people who could be harmed
or obstacles that could cause damage
prior to operating any slideout rooms.
Failure to observe can result in death or
serious injury.
Slideout rooms provide a spacious living area
at the push of a button.
Front slideout room switches (if equipped) are
located either on the dash, near the main entry
door, or near the Systems Monitor Panel.
Location varies by model and floorplan.
Rear slideout switches (if equipped) are
located on a wall near the slideout room or the
Systems Monitor Panel. Location varies by
model and floorplan.
SECTION 10 –
10-3