Location Requirements; Drain System - Whirlpool CGD9060 Installation Instructions Manual

Location Requirements

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the washer.
I
A grounded electrical outlet located within 6 ft. (1.8 m) of
I
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
Hot and cold water taps located within 4 ft. (1.2 m) of the hot
I
and cold water ll valves, and water pressure of 20–100 psi
(137.9–689.6 kPa).
A level oor with a maximum slope of 1" (25 mm) under entire
I
washer. Installing the washer on soft oor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid oor to support the washer with a total
I
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
The location must be large enough to allow the washer door
I
to be fully opened.
Additional spacing should be considered for ease of
I
installation and servicing. The door opens more than 90°,
and it is not reversible.
Additional clearances might be required for wall, door,
I
and oor moldings.
Additional spacing of 1" (25 mm) on all sides of the washer
I
is recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
I
Washer Dimensions
50 ½"
(1282 mm)
27"
(686 mm)
44 5 / "
8
(1134 mm)
28 13 / "
16
(732 mm)
A oor drain should be provided under the bulkhead. Prefabricated
bulkheads with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.

Drain System

The washer can be installed using the standpipe drain system
( oor or wall), the laundry tub drain system, or the oor drain
system. Select the drain hose installation method you need.
See "Tools and Parts."
Standpipe drain system – wall or oor (views A & B)
The standpipe drain requires a minimum diameter standpipe
of 2" (50 mm). The minimum carry-away capacity can be no less
than 12 gal. (45.5 L) per minute, per washer.
The top of the standpipe must be at least 30" (762 mm) high
and no higher than 96" (2.4 m) from the bottom of the washer.
A
Laundry tub drain system
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top
of the laundry tub must be at least 30" (762 mm) above the oor.
30" min.
(762 mm)
B
30" min.
(762 mm)
5