Location Requirements - Whirlpool CAE2765FQ0 Installation Instructions Manual

Commercial washer

Hide thumbs

Table of Contents

Selecting the proper location for your washer improves

performance and minimizes noise and possible washer "walk."

Your washer can be installed in a basement, laundry room, or

recessed area. See "Drain System."

Companion appliance location requirements should also be

considered.

IMPORTANT: Do not install or store the washer where it will be

exposed to the weather. Do not store or operate the washer in

temperatures at or below 32°F (0°C). Some water can remain in

the washer and can cause damage in low temperatures. Proper

installation is your responsibility.

You will need:

n A water heater set to 120°F (49°C).

n A grounded electrical outlet located within 4 ft. (1.2 m) of

power cord on back of washer. See "Electrical Requirements."

n Hot and cold water faucets located within 4 ft. (1.2 m) of hot

and cold water fill valves on washer, and water pressure

of 20–100 psi (138–690 kPa). A pressure reduction valve

should be used in the supply line where inlet pressure

entering the building exceeds 100 PSI (690 kPa) to avoid

damage to the washer mixing valve.

n Single washer installations require 12" (300 mm) minimum

risers to provide an air cushion and avoid noise and damage

to valves.

n A level floor with maximum slope of 1" (25 mm) under entire

washer. Installing on carpet is not recommended.

n Floor must support washer's total weight (with water and load)

of 315 lbs (143 kgs).

n A floor drain under the bulkhead. Prefabricated bulkheads

with electrical outlets, water inlet lines, and drain facilities

should be used only where local codes permit.