Installation Instructions; Requirements; Tools And Parts; Location Requirements - Whirlpool WFW6605MW Owner's Manual

INSTALLATION INSTRUCTIONS

REQUIREMENTS

Tools and Parts

Gather required tools and parts before starting installation.
Tools Needed:
Adjustable or open end
wrenches 1/2" (13 mm), 5/8"
(16 mm), and 9/16" (14.3 mm)
minimum
Wood block
Adjustable pliers that
open to 1 9 / " (39.7 mm)
16
Bucket
Parts Supplied:
NOTE: All parts supplied for installations are in the washer.
Drain hose with clamp, U-form,
and cable tie
Parts Needed: (if not supplied with washer)
Inlet hoses with flat washers
10
Level
Ruler or measuring tape
Flashlight
NOTE: Various inlet hose
options are available; check
your Quick Start Guide for
ordering information.
Available Accessories
An optional matching pedestal is available for your washer. Please
contact your retailer for ordering information, or see your Quick
Start Guide.
Alternate Parts (not supplied with washer)
Your installation may require additional parts. To order, please
refer to contact information on your Quick Start Guide.
If you have: You will need:
Overhead sewer Standard 20 gallon (76 L) 39" (990 mm)
tall drain tub or utility sink, sump pump,
and connectors (available from local
plumbing suppliers)

Location Requirements

IMPORTANT: Do not install, store, or operate washer where it will
be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer after use may cause damage in low
temperatures. See "Washer Maintenance and Care" for
winterizing information.
Select proper location for your washer to improve performance
and minimize noise and possible "washer walk." Install your
washer in a basement, laundry room, closet or recessed area.
Proper installation is your responsibility.
You will need
� A water heater set to 120°F (49°C).
� A grounded electrical outlet located within 6 feet (1.8 m) of
power cord on back of washer.
� Hot and cold water faucets located within 4 feet (1.2 m) of hot
and cold water fill valves on washer, and water pressure of
20–100 psi (137.9–689.6 kPa).
� A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet or surfaces with foam backing is
not recommended.
� Floor must support washer's total weight (with water and load)
of 315 pounds (143 kg).
All dimensions show minimum spacing allowed. For each
arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and floor moldings. Space must
be large enough to allow door to fully open. Add spacing of
1" (25 mm) on all sides of washer to reduce noise transfer. If a
closet door or louvered door is installed, top and bottom air
openings in door are required.
NOTE: For additional details (or information) specific to your
model, refer to your Quick Start Guide.