Disassembly And Assembly - Pride CELEBRITY X Owner's Manual

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into seven pieces:
the seat, the front section, the rear section, the rear
shroud, the basket, and the batteries. See figure 20.
No tools are required to disassemble or assemble
your scooter, but keep in mind that the disassem-
bled sections of the scooter take up more floor
space than the assembled unit. Always disassem-
ble or assemble your scooter on a level, dry surface
with sufficient room for you to work and move
around your scooter—about 6 feet (2 meters) in all
directions. Remember that some scooter compo-
nents are heavy and you may need assistance when
lifting them.
WARNING! Do not lift beyond your
physical
assistance when necessary while
disassembling or assembling your
scooter.
1. Place the scooter in drive mode by engaging the freewheel lever.
2. Lock the tiller in the straight ahead position by pushing the tiller lock knob in and turning it clockwise
90°. See figure 21. The front wheel must face forward in order to lock the tiller.
3. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when
removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up
on the seat.
4. Gently pull the rear shroud up and off of the rear section of the scooter.
5. Unplug the front-to-rear and rear lighting harnesses by squeezing the sides and pulling straight up.
6. Unplug both battery harnesses. Pull each harness straight up. See figure 22.
7. Unfasten the battery tie-down straps and remove the batteries from the battery wells.
LOCKED POSITION
Figure 21. Tiller Lock Knob (Locked)
36
capability. Ask for
www.pridemobility.com
REAR SECTION
REAR
FRONT SECTION
SHROUD
Figure 20. The Scooter Disassembled
UNLOCKED POSITION
Figure 21A. Tiller Lock Knob (Unlocked)
SEAT
BATTERIES
BASKET
Celebrity X