Pride CELEBRITY X Owner's Manual page 37

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
8. Squeeze the tiller adjustment lever and lower
the tiller to its lowest point. Adjust the tiller
console if necessary.
WARNING! Failure to unplug both
battery harnesses, the front-to-rear
harness, and rear lighting harness
prior to separating the front and
rear sections
permanent damage to the scooter.
Frame Separation
1. Lift up on the frame release lever. See figure 23.
2. Lift the front section up until the frame hooks
of the front section separate from the rear sec-
tion. See figure 23.
NOTE: Stabilize the rear section with your free
hand by holding onto the upper frame tube. See
figure 24.
3. Slowly separate the two sections. See figure 24.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 24.
2. Use the frame release lever to lift the front sec-
tion as you align the frame hooks of the front
section with the lower frame tube of the rear
section. See figure 23.
3. Once the frame hooks are over the lower frame
tube, lower the front section completely. This
will engage the frame lock.
4. Raise the tiller.
5. Reinstall both batteries and secure with the
battery tie-down strap, making sure the strap is
positioned over the frame release lever to
ensure proper securement.
6. Connect the front-to-rear harness, rear lighting
harness, and both battery harnesses. See figure 22.
7. Reinstall the rear shroud.
8. Reinstall the seat and rotate it until it locks into place.
9. Unlock the front wheel by turning the tiller lock
knob 90° counterclockwise. See figure 21A.
WARNING! After assembly, make
absolutely certain the tiller lock
knob is in the unlocked position
before riding your scooter.
Celebrity X
could result in
www.pridemobility.com
REAR LIGHTING HARNESS
BATTERY
HARNESSES
Figure 22. Harness Connections
FRAME RELEASE LEVER
FRAME LOCK
Figure 23. Frame Release
UPPER FRAME TUBE
LOWER FRAME TUBE
Figure 24. Frame Separation
FRONT-TO -REAR HARNESS
FRAME HOOK
FRAME HOOK
37