Pride VOGUE Owner's Manual page 23

I V . C O M F O R T A D J U S T M E N T S
Power Positioning Systems Adjustment
Your power chair may be equipped with a power recline, power tilt, or power elevating leg rest system. You can
change the position of these options through the controller.
To adjust power positioning systems:
1. Push the on/off key to power on the chair and the controller. See figure 11.
2. Push the desired actuator key to select actuator mode. See figure 11.
3. Push the joystick forward to move the chosen actuator to the desired position.
4. Pull the joystick rearward to return to your starting position.
5. Push the on/off key to return to drive mode. See figure 11.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
NOTE: For more information on operating the power positioning systems, contact your authorised Pride Provider.
WARNING! The power positioning systems are intended for use on a level surface only. Never
operate your power chair while tilted or reclined on an inclined surface. Failure to heed this
warning can result in the power chair tipping over.
WARNING! Never operate your power chair while tilted or reclined on bumpy or uneven surfaces.
Failure to heed this warning can result in the power chair tipping over.
WARNING! Never operate the power positioning systems while your power chair is in the
freewheel mode.
WARNING! Always fasten the positioning belt when operating the power positioning systems.
WARNING! Pinch Point Hazard! Keep area around actuator clear when operating the power
positioning systems or returning to your starting position.
JOYSTICK
Figure 11. VR2 9-key Controller and Keypad
Vogue
BATTERY CONDITION METER
HORN KEY
HAZARD LIGHT KEY
SPEED/PROFILE
DECREASE KEY
LEFT TURN
INDICATOR KEY
ACTUATOR SELECT KEY
www.pridemobility.com
HAZARD LIGHT KEY
HEADLIGHT KEY
MAXIMUM SPEED/
PROFILE SELECTION
SPEED/PROFILE
INCREASE KEY
RIGHT TURN
INDICATOR KEY
23