Pride VOGUE Owner's Manual page 27

I V . C O M F O R T A D J U S T M E N T S
To extend the controller:
1. Loosen the setscrews in the mounting block. See figure 18 or 19.
2. Slide the controller into or out of the mounting block to the desired position.
3. Tighten the setscrews to secure the controller.
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip
wheels are preset at the factory for smooth surfaces or indoor use only. If you plan on using your power chair on
rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may
need adjustment if either of the following occur:
When accelerating, your power chair tips rearward excessively.
The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorised Pride Provider before attempting to change the anti-tip
wheel height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair's
tendency to tilt rearward when accelerating. You can compensate for this by having your
authorised Pride Provider make a small adjustment to the pre-programmed acceleration setting
in the controller or by adjusting the seat assembly.
WARNING! The anti-tip wheels may cause trouble when ascending or descending a kerb if they
are not adjusted correctly. Contact your authorised Pride Provider for more information.
To adjust the anti-tip wheels:
1. Remove both bolts from the anti-tip wheel bracket. See
figure 21.
2. Raise or lower the anti-tip wheel in 1.25 cm (0.5 in.)
increments by aligning the appropriate adjustment holes.
See figure 21.
3. Reinstall and tighten both bolts.
4. Raise or lower the other anti-tip wheel so that it is at the
same height.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tyre must be inflated to the the psi/bar/
kPa air pressure rating indicated on each tyre in order for
the anti-tip wheels to be properly adjusted. The user must
also be seated in the power chair in order to properly adjust
the anti-tip wheels.
Vogue
ANTI-TIP
WHEEL
Figure 21. Anti-Tip Wheel Assembly
www.pridemobility.com
BOLTS
ANTI-TIP
WHEEL
BRACKET
27