Teeter Hang Ups EP-550 Assembly Information page 6

Support Beam
Upper Support Arms
Figure 3
Figure 4
Step 2
Attach the Upper Support Arms to the Table Bed (EP-1140)
• Before following this step, make sure you have read the orange insert that came attached to the Table Bed.
• Place the Table Bed face down on the floor and push down on the Support Beam, so the two holes align
evenly with holes at the base of Upper Support Arms (Figure 3). You may have to exert extra pressure to
ensure the Support Beam slides over the rubber spacers.
• Insert the two bolts (EP-1149) into the open holes.
• Fasten each bolt with a nut.
• Use the Allen Wrench (IA-1149) to steady the bolts, tighten the nut onto the bolt with the larger wrench
(F5-1088) (Figure 4). Repeat with the second bolt.