Teeter Hang Ups EP-550 Assembly Information page 13

Figure 16
A B C
Figure 17
Figure 18
Adjustments / Maintenance / Storage
CHANGING THE ROLLER HINGE SETTING
• Stand with your legs on either side of the Main Shaft.
• Reach under each Roller Hinge with your index fingers. Use your thumbs to release the locks over
the Roller Hinges (See Figure 16).
• Lift both sides of the table out of the A-frame at the same time. You may rest the table on the
Crossbar of the A-frame.
• Unlock the Cam Locks for each Roller Hinge. Change the Roller Hinges to the desired setting
(A, B or C) (Figure 17).
• Re-lock the Cam Locks. Replace the Roller Hinges into the hinge plates of the A-frame.
MAINTENANCE
• To clean the Table Bed, wipe down with a damp cloth. Do not use abrasive cleaners.
STORING THE INVERSION TABLE
• Loosen the De-rattler knob.
• Pull the height-selector locking pin and slide the Main Shaft in all the way to the final hole setting.
Engage the pin in the storage setting.
• Rotate the table opposite from use until the table has turned 180 degrees and rests against the
Crossbar on the A-frame.
• Pull up on the spreader arms to fold the A-frame (Figure 18). WARNING: This operation may
pinch fingers if not done slowly and carefully.
Tipping Hazard: For upright storage, leave A-frame open wide enough to remain stable, or secure to the wall
to prevent tipping. In households with small children, the table should be stored flat on the floor, not upright
! WARNING
.