Teeter Hang Ups EP-550 Assembly Information page 5

Right
spreader arms
Crossbar
front
Figure 1
Figure 2
Left
Assemble the A-frame Base (F7-1002) and Install the Handles (F5-1069)
• Open the A-frame and make sure the spreader arms are locked, rest the A-frame on the floor (Figure 1). The
Crossbar is at the front.
• Place each Hand Grip (left/right) over the outside edge of the corresponding Hinge Plate (Figure 2).
• Insert three 1/2" (13mm) hex bolts (H1-1202) through the hinge plate into each Hand Grip. Use the wrenches
provided to tighten the bolts, being careful not to over-tighten.
back
Step 1