Table of Contents
Advertisement
1. Loosen the screws of the
upper cover and side panel.
4. Turn the device upside down
and then turn the screws in
firmly.
in the chassis.
7. Put the cover in accordance
with the clip and then place the
upper cover back.
3.3.4 NVR44/44-8P/44-16P/74/74-8P/74-16P/ Series
The following figures are based on the NVR74 series.
① Use the screwdriver to loose the screws of the rear panel and then remove the front cover.
2. Fix four screws in the HDD
(Turn just three rounds).
5.
Fix the HDD firmly.
8. Secure the screws in the rear
panel and the side panel.
3. Place the HDD in accordance with
the four holes in the bottom.
6. Connect the HDD cable and
power cable.
67
Advertisement
Table of Contents
