Record And Snapshot; Encode - IC Realtime NVR11 Series User Manual

Call Scan
In Figure 4-34, input Scan value and then click
Rotate
In Figure 4-34, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:

Preset, tour and pattern all need the value to be the control parameters. You can define it as y ou
require.
 You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-40.

4.7 Record and Snapshot

The record/snapshot priority is: Alarm->Motion detect->Schedule.

4.7.1 Encode

4.7.1.1 Encode
Encode setting is to set IPC encode mode, resolution, bit stream type and etc
From Main menu->Setting->System->Encode, you can see the following interface. See Figure 4-41.

Channel: Select the channel you want.

Type: Please select from the dropdown list. There are three options: regular/motion detect/alarm.
You can set the various encode parameters for different record types.

Compression: System supports H.264, MPEG4, MJPEG and etc.
Resolution: The mainstream resolution type is IPC's encoding config. Generally there is

D1/720P/1080P.

Frame rate: It ranges from 1f/s to 25f/s in NTSC mode and 1f/s to 30f/s in PAL mode.

Bit rate type: System supports two types: CBR and VBR. In VBR mode, you can set vi deo quality.
to enable the camera to rotate.
Figure 4-40
to call a tour. Click again to stop call.
111