Table of Contents
Advertisement
4.4.6 UPNP
Important
Do not connect the switch to the PoE port, otherwise the connection may fail!
Please connect the IPC to the PoE port of the device rear panel (Figure 4-18), system can auto connect
to the network camera. Please note the following figure is for reference only.
4.4.7 Built-in Switch Setup
The built-in switch function is for product of PoE port.
From Main menu->Setting->Network->Switch, you can set switch IP address, subnet mask, gateway and
etc. See Figure 4-19.
4.5 Preview
After device booted up, the system is in multiple-channel display mode. See Figure 4-20.Please note the
displayed window amount may vary. The following figure is for reference only. Please refer to chapter 1.3
Specifications for the window-amount your product supported.
Figure 4-18
Figure 4-19
97
Advertisement
Table of Contents
