Remote Control Features; Remote Control Maintenance - Zephyr Tornado II AK8200AS Use, Care And Installation Manual

FCC Caution:
To assure continued compliance, any changes or modifi cations not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface
cables when connecting to computer or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
This remote control may operate in humid environments, but not when placed on a wet surface.

REMOTE CONTROL FEATURES:

The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such
as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.
Blower On/
Blower On/
1 2
Speed Selection
Power Off
3 4
Lights On/Dim/Off
5 Min Delay Off
+
A
1. Place remote control on the counter near the hood (make sure a good battery is installed).
2. Disconnect power from the hood by turning off circuit breaker.
3. Reconnect power to the hood.
Follow this procedure whenever the remote control does not work.
Blower On/Speed Selection
1
By pressing
three blower speeds.
Blowers On/Hood Off
2
By pressing
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
appear in the lower right corner of the power pack display
function is on. The blower will change to speed 1 and shut down after 5
minutes.
Lights On/Dim/Off
4
Switch lights On by pressing

REMOTE CONTROL MAINTENANCE:

Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
Using a small fl at head screwdriver, raise the cover of the battery door (A) in
order to access the battery compartment.
-
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.
If the remote control does not work after installation (yet the hood works
correctly):
14
www.zephyronline.com
, the blower is switched On. Press
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay Off mode. A dot will
once, again to dim and again to switch Off.
again to cycle through all
indicating the