Closing Camper For Travel - Jayco Eagle Owner's Manual

12. Insert canvas by folding the hard edge of tent over 180º and inserting this portion
into channel of screen door, starting at the bottom. This assures the best possible fit.
13. On units without slideout, set up kitchen flip top and attach the stove grate.
14. Exit unit and pull bed flaps over corners of bed until flaps are extended under the
bed. Securely attach Velcro.
WARNING: Ensure that all Velcro fasteners are mated and securely fas-
tened. Loose areas could result in openings large enough for an infant, child or
adult to fall through. Never leave small children in the camper unattended.
CAUTION: The roof has a weight limit of 350 pounds in the travel mode. The
maximum weight that can be lifted is 250 pounds. The items in the soft storage
compartments will need to be included in this final total. Remove all soft storage
compartments before lowering or raising the roof. Weights for the soft storage
compartments are as follows:
SofStor™ Overhead Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 lbs.
SofStor™ Wardrobe Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 lbs.
SofStor™ Organizer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 lbs.
Kid Stuf Cargo Bunk Organizer . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 lbs.
Fig. 3-2
Fig. 3-4
Fig. 3-7
Fig. 3-3
Fig. 3-5 Fig. 3-6
26

Closing Camper for Travel

INSIDE
1. Enter camper and remove all soft storage components.
2. Remove canvas from screen door by pulling canvas away from channel, beginning at
the TOP of door, proceeding to bottom.
3. Swing screen door up to roof and latch the twist locks.
4. Zip all windows closed.
5. Roll all privacy drapes upward by pressing both buttons on either side of the black
locks and drawing the locks upward.
6. Remove bow braces located in the bed and slideout areas from bracket on the roof
and pull brace to center of coach. Remove from saddle plug on bed bow. Place bows
under bed mattress. (Fig. 3-7)
7. Remove stove grate and stove. Place kitchen flip top in travel position.
CAUTION: Failure to properly position the kitchen flip-top for travel can result in
roof damage and prevent the roof from lowering properly.
OUTSIDE
8. Raise the stabilizer jacks to their upright position. Insert crank and turn counter-
clockwise until jack is tight, then turn crank an additional 1/8 of a turn (snug tight).
Fig. 3-8
27