Table of Contents
Advertisement
Keypad 10 Line Lock
Chain Programming
When programming multiple User Numbers and Codes into the
10 Line Keypad Lock, it is not necessary to leave and re-enter the
programming mode (50) for each entry. Multiple entries may be chained
together and the three different types of user codes (Standard, Passage
and One Time) may be mixed.
The format to be used is as follows where:
"T" is the Type of user code with "1" Standard, "2" Passage and "3" One Time.
"UN_" is User Number (04-99)
"UC_" is User Code (2 to 6 digits) which correlates with the User Number 99# Master or Supervisor
Code* 50# Type# User Number a# User Code a*
User Code a* T# UNb# UCb* UCb* T# UNc# UCc* UCc* ...... T# UN_# UC_* UC_**
An example with four user codes is shown below:
Type
User Number
1
05
3
12
2
08
1
50
Using Master Code 4732 and above information, the lock would be programmed as follows:
99# 4732* 50# 1# 05# 875* 875* 3# 12# 2226* 2226* 2# 08# 5444* 5444* 1# 50# 3367*
3367**
If all user codes are the same type, it is not necessary to enter the type number with each
entry. The type number has to be entered with the first user code only.
The format now simplifies to:
99# Master or Supervisor Code* 50# Type# User Number a# User code a* User Code a*
UNb# UCb* UCb* UNc# UCc* UCc*....... UN_# UC_* UC_**
An example with three user codes is shown below:
Type
User Number
1
07
1
15
1
91
Using Master Code 45988 and above information, the lock would be programmed as follows:
99# 45988* 50# 1# 07# 77* 77* 15# 67832* 67832* 91# 7568* 7568**
To chain the User Number delete procedure:
99# Master Code* User Number a#** UNb#** UNc#**....... UN_#****
Using the information from the above example:
99# 45988* 07#** 15#** 91#****
16
800-810-WIRE (9473) • www.sargentlock.com • A7113E
User Code
875
2226
5444
3367
User Code
77
67832
7568
Hide quick links:
Advertisement
Table of Contents
