Spacer Bushing - Assa Abloy KP10G77 Installation Instructions Manual

Keypad 10 Line Lock
Step #5 Lock Installation
Lock Preset to:
• Through-bolt location– 12 & 6 o'clock
• Door thickness– 1-3/4" thick- see below for other door conditions
Adjustment for different through-bolt and door thickness:
• Remove outside lever (usually keyed), scalp and spacer bushing
• Rotate mounting plate to either align with through-bolt holes in door,
or adjust for proper door thicknesses (see markings on through-bolt)
• Reinstall spacer bushing (to align with back of lever) scalp and lever
1. Feed wires into the lock body hole from outside of door
2. Install lock body into cross-bore hole from outside of the door (locked side)
3. Lock body must engage both the latch unit prongs and tail piece (as shown)
1
For wood
door only
Inside
of door
1-3/4" thick door
2" thick door
Screws partially
tightened
3
Through-bolt
holes
2
IMPORTANT:
Door must remain open
during installation.
Use door stop.
A7113E • 800-810-WIRE (9473) • www.sargentlock.com

Spacer bushing

Rotate to match
through-bolt holes in door
IMPORTANT:
Lockbody
must be
centered in
the door.
7