Table of Contents
Advertisement
Turning the unit on/off (continued)
To cancel quick start
Press the menu button, use the cursor button to select [
[
QUICK START]#[OFF]. (P29)
≥ Turn off the power to cancel quick start
standby. The status indicator goes out
and the power turns off.
≥ Quick start standby is cancelled after
5 minutes have elapsed. In this case,
turn off the power and then turn it on
again or open the LCD monitor again.
The unit cannot be quick-started and it
takes longer for it to start operating.
≥ Quick start standby is cancelled and the
power turns off if the mode dial is
switched to a mode other than motion
picture recording mode or still picture
recording mode.
≥ Since about half the power of normal
recording is used in quick start standby,
using quick start reduces the recordable
time.
≥ If quick start is not set, it takes longer for
this unit to start operating, but the
amount of power consumed when the
LCD monitor is closed is reduced.
22
VQT0X49
SETUP]#
≥ When the LCD monitor is opened in
quick start standby status, the zoom
magnification is set to the 1k
(approximately). This may cause the size
of the image to be different from the size
before standby status was established.
≥ When this unit is quick-started with the
white balance on automatic, it may take
some time until the white balance is
adjusted if the scene being recorded has
a light source different from the scene
last recorded. (When the colour night
view function is used, however, the white
balance of the scene last recorded is
retained.)
Advertisement
Table of Contents
