Table of Contents
Advertisement
Trouble shooting (continued)
Problem
The scenes are not
correctly displayed in
thumbnails.
"PUSH THE RESET
SWITCH." is displayed.
If the SD card is inserted
in another device, it is
not recognized.
Even if connected by the
USB cable, this unit is
not recognized by the
PC.
When the USB cable is
disconnected, an error
message will appear on PC.
The warning/alarm
indication [°] appears
when this unit is operated
in the WEB camera mode.
The [
] indication
PictBridge
flashes when this unit is
connected to a PC.
The [
] indication
WEB
appears when the unit is
connected to the printer.
106
VQT0X49
≥ Scenes displayed as thumbnails
in shades of blue and white
cannot be played back or
deleted. If the scenes are
unnecessary, format the SD
card to erase the data.
≥ Please be aware that if an SD
card is formatted, then all the data recorded on the card
will be erased. Store important data on a PC, etc. When
saving scenes recorded using this unit to a PC, you
must use MotionSD STUDIO. (P77)
≥ The unit has automatically detected
an error. To protect the data, remove
the SD card and then press the
[RESET] button with the projecting
part 1 of the hand strap. This will
restart the unit. When you press the
[RESET] button, the date and time
setting will also be reset. Set the date
and time again.
≥ Even after you press the [RESET] button, the indication
may still appear repeatedly. If so, this unit needs repair.
Detach the power connected, and consult the dealer
who you purchased this unit from. Do not attempt to
repair the appliance by yourself.
≥ Check that the device is compatible with the capacity or
type of SD card (SD Memory Card/ SDHC Memory Card)
that you inserted. (P17)
> Refer to the operating instructions of the device for
details.
≥ Have you installed the Web camera driver?
> Install the driver, then check the connections.
≥ Have you set this unit to the correct mode?
> The unit is not recognized if it is set to motion picture
playback mode. (P84)
≥ Select another USB terminal on the PC.
≥ Check the operating environment. (P79, 80)
≥ Turn on the power to this unit.
≥ To disconnect the USB cable safely, double-click the
icon in the task tray and follow the instructions on the
screen.
≥ Did you press the record button or any other button?
> You cannot record onto the card in the WEB camera mode.
≥ Have you installed the Web camera driver?
> Install the driver, then check the connections.
≥ The unit is connected to a Windows XP PC in still
picture playback mode.
> Connect with a printer supporting PictBridge.
≥ The unit is connected to the printer in motion picture
recording mode or still picture recording mode.
> Change the mode to still picture playback mode.
Check points
SETUP
1/3
1/3
1/3
PLAY
1
Advertisement
Table of Contents
