Table of Contents
Advertisement
Quick start
If quick start is set and then the LCD monitor is closed while the unit's power is still on,
the unit will be ready for recording about 1.5 seconds after the LCD monitor is next
opened.
Use the quick start function when stopping recording for a few moments.
≥ The quick start function can be set in the following cases.
– In motion picture recording mode, when the SD card is inside this unit
– In still picture recording mode, when the SD card is inside this unit
To set quick start function
SETUP
DISPLAY
DATE/TIME
DATE FORMAT
FORMAT CARD
QUICK START
SETUP
ENTER
1
A
B
1/3
OFF
ON
EXIT
MENU
2
Press the menu button B, use the
cursor button A to select
[
SETUP]#[
then set the function to [ON]. (P29)
When the LCD monitor is closed, the quick start
standby mode is established.
1 The status indicator lights green.
≥ If quick start is set, the lens cover does not
close.
If the quick start function is set
When the LCD monitor is opened, the unit
goes into recording standby.
2 When the LCD monitor is opened, the status
indicator lights red.
QUICK START], and
VQT0X49
21
Advertisement
Table of Contents
