Installing The Custom Door Front - Miele KFNS 37692 iDE Operating And Installation Instructions

Installing the custom door
front
The cabinet door must be at least of
5/8" (16 mm) thick and not exceed 3/4"
(19 mm) thick.
The following gap dimensions must be
maintained:
– The gap between the cabinet door
and the unit door above must be at
least 1/8" (3 mm).
– The vertical gap between cabinet
doors should also be about 1/8"
(3 mm). The exact dimension will
vary depending on the radius of the
cabinet door edges.
If fitted in a run of units make sure that
the top edge of the cabinet door is at
the same height as neighboring unit
doors.
The door panel must be installed
correctly and not under tension.
Installing the appliance
Installing a door front which is
heavier than the maximum permitted
could damage the hinges. This can
cause damage.
Before installing door fronts ensure that
the weight of the door does not exceed
the maximum permitted:
Appliance
KFNS 37692 iDE
When fitting large or divided cabinet
doors an extra fitting kit or set of
fixing brackets should be used.
These are available to order from
Miele.
Max. Max.
weight weight
of of the
upper lower
cabinet cabinet
door in door in
lb (kg) lb (kg)
44 (20) 26 (12)
103