Attaching And Aligning The Custom Door Front - Miele KF 1801 Vi Operating And Installation Instructions

Installing the appliance
Please note: When attaching the
mounting frame onto two adjacent
doors (see "Front panel gap kit")
screw into the thicker outer frames
of the doors only.
The bracket includes a variety of holes
for the various design options of
custom doors.
When performing work on the custom
door, always observe the following:
– Always select the best load-bearing
surface of the custom door as the
location for screws.
– Always select a screw length that is
shorter than the thickness of the door
front.
70
Attaching and aligning the
custom door front
^ Fit the door handle to the custom
door.
Note that the screws are applied from
the reverse side.
^ Open the door and hang the custom
door with the adjusting rail over the
double-threaded bolts p.
^ Screw the nuts q a few turns onto
the double-threaded bolts. Do not
tighten completely.
^ Close the door.
^ Adjust the custom door to adjacent
furniture/fixtures.