Changing The Size Of The Ice Cubes; Setting The Water Quantity - Miele KFNS 37692 iDE Operating And Installation Instructions

Making ice cubes
If you require a large quantity of ice
cubes,
^ replace the full ice cube drawer with
the drawer beside it on the right.
The ice cube maker will begin to
produce ice cubes again as soon as
this new drawer has been placed in
position and closed properly.

Changing the size of the ice cubes

The size of the ice cubes depends on
the quantity of water being taken in.
You are able to set this quantity
according to your wishes.

Setting the water quantity

The size of the produced ice cube
depends on the water pressure and set
water intake time of the ice cube maker.
If, for example, the ice cube maker
only makes small ice cubes, the water
pressure is low. To produce larger ice
cubes, the water quantity of the ice
cube maker must be increased. A
medium-sized water quantity (E3) has
been set at the factory.
The setting can only be selected if
the ice cube maker is turned on.
^ Touch the settings button.
All symbols available for selection will
appear in the display and the 0 symbol
flashes.
50
^ Touch the buttons for setting the
temperature (X or Y) repeatedly until
the symbol for the ice cube maker ®
flashes in the display.
^ Touch the OK button to confirm your
selection.
^ The X and Y buttons can be used to
set whether the water quantity is to
be changed:
0: Ice cube maker is switched off
1: Ice cube maker is switched on
2: Set the water quantity
3: Ice cube tray cleaning position
4: Rinse the ice cube maker
^ Touch the OK button to confirm your
selection.
^ Touch the X and Y buttons to set the
required water quantity (E1 to E8):
E1: small quantity
E8: large quantity
^ Touch the OK button to confirm your
selection.
The selected setting will be adopted.
^ Touch the settings button to leave
settings mode,
or
^ close the appliance door.
The electronics will otherwise switch to
normal operation after one minute.