Before Installation - Miele KFNS 37692 iDE Operating And Installation Instructions

Before installation

^ Before installation, remove the
accessories bag containing
installation components and
accessories from the appliance, and
remove the sealing strip from the
appliance door.
^ Do not remove the following from the
back of the appliance:
– The spacers (depending on model).
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– Depending on model, the pouches
located in the metal grille (heat
exchanger).They are required for the
correct functioning of the appliance.
The contents are not poisonous or
dangerous.
^ Remove any cable clips from the
back of the appliance.
^ Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
Installation information
^ Open the appliance door and remove
the red safety catch a (depending
on model).
Spacers on the back
If the depth of the unit is less than
21 3/4" (553 mm) remove the spacers
on the back of the appliance in order to
be able to push the appliance
completely into the recess. Removing
the spacers may cause the appliance
to use mor energy as this reduces the
ventilation cross-section.
^ Undo the screw and remove the
spacers.
89