Cleaning; General Inspection; Repairs - 909 LS1620 Instruction Manual

Cleaning

1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.

General inspection

Regularly check that all the fixing screws are tight.
They may vibrate loose over time.

Repairs

Only an authorised service centre should replace the cordset
or effect other repairs. If the cordset is damaged or worn,
have it repaired or replaced by an authorised service centre.
14