Table of Contents
Advertisement
4.
Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi
Broadband Router. You can refer to the following if you are having problems.
1 Why can't I configure the router even the cable is
plugged and the LED is lit?
Note:
It is recommended that you use an Ethernet connection to configure it
Check Ping test to make sure that the iB-WRC300N Router is responding.
Go to Start > Run.
1.
Type cmd.
2.
Press OK.
3.
Type ipconfig to get the IP of default gateway.
Type "ping 192.168.1.1". Assure that you ping the correct IP Address assigned
4.
to the 300M MIMO ADSL2+ Broadband Router. It will show four replies as below.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
62
Hide quick links:
Advertisement
Table of Contents
