Ideal Security SK634 Instruction Manual page 8

WIRELESS INDOOR/OUTDOOR SIREN & STROBE LIGHT
Description of Components
1. Antenna
2. Arm / Battery low / Trigger indication LED ( red )
3. Strobe light
4. AC indication LED ( green )
5. Siren / Light function switch
6. LEARN button
7. Alkaline / Recharge switch
8. DC Jack
9. Entry delay switch
10. Battery cover
Installation
• Remove the screws from the battery compartment cover (Fig. 8).
• Set the Entry delay (0 / 10 seconds) timer switch.
• Set the battery type switch.
WARNING: Failure to choose the correct setting will damage this unit.
If you use non rechargeable batteries the switch must set to ALKALINE.
If you use rechargeable batteries the switch must be set to RECHARGE.
NOTE: UNIT WILL NOT RECHARGE BATTERIES .
• Install 4 AAA batteries (included), or 4 AAA 700mAh NI-MH rechargeable
batteries (not included). Batteries provide Back-up power for emergency
functionality in case of power failure.
• Set the Siren / Light function switch.
• Temporarily remove the water resistant rubber cover to select the alarm function.
Set the switch to: Siren only / Siren+Strobe light / Strobe light only. Replace cover.
• Plug the AC adaptor to the DC 6V jack. The AC power indication
LED will show a steady light (Fig. 9).
• The Siren included with this kit is factory linked to the Auto Dialer.
• Normal transmision range is between 40 - 60 meters (130' -200')
• Mount in a sheltered area protected from the elements.
WIRELESS REMOTE CONTROLS
Description of Components
1. Panic button
2. Disarm Button
3. Arm button
4. Battery compartment
Installation
Install the CR2032 battery included into the remote control (Fig. 10).
• Remote controls for Arm, Disarm functions of the Telephone Dialer.
• Remote range from receiver is up to 25 meters (80 feet).
• The Remote Controls included with this kit are factory linked to the auto dialer.
If the remote has to be moved closer to the receiver in order to function please
replace batteries. The battery life is about six months under normal use.
NOTE: If you wish to change the factory programed zone location of the sensors see:
LINK WIRELESS SENSORS TO THE AUTO DIALER.
1
2
3
1
3
7
2
4
BAT.LOW AC
5
6
4
(Fig. 10)
9
ALKALINE 10S
RECHARGE 0S
8
10
DC 6V
LEARN
ALKALINE 10S
RECHARGE 0S
(Fig. 8)
(Fig. 9)
ALKALINE 10S
RECHARGE 0S