Battery Low Indicator - Ideal Security SK634 Instruction Manual

• The maximum detection range (left to right) is 110 degrees for a maximum distance up to 8m (26').
• Test the area requiring coverage before mounting the sensor permanently.
• The LED on the front of the unit will flash continuously when motion is sensed.
• Use the swivel wall mount bracket to mark the mounting location, drill holes and install anchors and attach the bracket
with the screws provided. Slide the main unit onto the bracket until it clicks into place (Fig 5). Adjust the bracket to obtain
the best coverage of the intended protected area (Fig 6).
1.5~2m
(5'~6')

BATTERY LOW INDICATOR

When the battery is low, the LED on the front of the unit will flash on 3 seconds and off 1 second. Replace the battery
immediately to maintain proper detection. If batteries are low they may send a false signal to the auto-dialer. Batteries in all
units should be replaced at least once per year.
DOOR/WINDOW SENSORS WITH VIBRATION DETECTION
Description of Components
1. Trigger/ battery low LED
2. Alarm speaker
3. Antenna
4. Wired contact
Installation
• Install the 9V battery (included) into the two door and window sensors (Fig. 7).
• These two sensors are factory linked to zone 2 and 3. When one of the sensors
is triggered either zone 2 or zone 3 will flash on the screen.
• The LED on the front of the unit will flash continuously when the contacts are open.
• Determine appropriate location for the contacts on the door or window to be protected.
• Mount the wired portion of the contact to the door or window frame and the
magnetic contact portion to the door or window.
• For maximum vibration detection the sensor should be mounted on or as close to the frame of the door or window as
possible. Before using the double sided tape provided, align the 2 sensor portions so that they are flush and with the align-
ment arrows facing each other and no more then 1/4" apart. Make sure to extend the antenna on the sensor for the best
transmission range.
• The Door/Window Sensors have built-in 105 dB alarms which will sound for one 10 second burst when the contacts
have separated or the detector senses vibration. This feature can be controlled with the ALARM ON/OFF switch
on the side of the unit.
BATTERY LOW INDICATOR
When batteries are low, the LED on the front of the unit will flash on 3 seconds and off 1 second. Replace the batteries
immediately to maintain proper detection. If batteries are low they may send a false signal to the auto-dialer. Batteries in all
units should be replaced at least once per year.
(Fig. 5)
5~8m (16~26')
5. Magnetic contact
6. Alignment arrows
7. Alarm ON/OFF switch
8. Battery compartment
110°
(Fig. 6)
3
1
6
2
4 5
(Fig. 7)
7
8