Installation Of Sensors; Motion Sensor - Ideal Security SK634 Instruction Manual

10. TO PROGRAM CALL-IN RING DETECT CYCLE (how many rings before auto dialer will answer).
The auto dialer has been factory preset to answer after the 5th ring. The call-in ring detect cycle is for how many times you
want the phone to ring before the auto-dialer picks up. You can arm/disarm and monitor your home via the telephone.
• Enter the password followed by the PROG button seven (7) times.
• The " " symbol will flash on the screen.
• Press ARM/DISARM button to confirm.
• Using the */UP and #/DOWN buttons select 3, 5, 7 or 10 (which represents the # of rings before the auto dialer picks up)
followed by the ARM/DISARM button to confirm.
• Press the PROG button three (3) times to exit set-up mode.
NOTE: You cannot use an answering machine with this feature. If you want to be able to call in to the auto dialer you must
program it to answer before your answering machine does. Example if your answering machine answers after 4 rings,
you must set the auto dialer to answer at 3 rings.
11. TO PROGRAM INTERNAL 105 dB AUTO DIALER SIREN ON/OFF
The auto-dialer has been factory pre-set with the siren ON. To change this to OFF:
• Enter password followed by PROG button four (4) times.
• The " " icon will flash on the auto-dialer screen. (Fig. 8)
• Press ARM/DISARM to confirm.
• Using */UP or #/DOWN buttons to select SOUND OFF.
• Press ARM/DISARM button to confirm.
• Press PROG button six (6) times to exit the set-up mode.
12. TO PROGRAM ENTRY DELAY TIME: (Time allowed to deactivate system once you have entered your residence)
The auto-dialer has been factory pre-set with a 20 second delay. To change the delay time to 0, 5, 10, 15 or 20 seconds:
• Enter password followed by PROG button eight (8) times.
• "ENTRY" will flash on the auto-dialer screen.
• Press the ARM/DISARM button to confirm.
• Using the */UP and #/DOWN buttons select the seconds 0,5,10,15 or 20
• Press ARM/DISARM to confirm the number of seconds you require for the entry delay time.
• Press the PROG button twice (2) to exit set-up mode.

INSTALLATION OF SENSORS

Before installing Sensors permanently you should test the signal range. Transmission distance from sensors to the
auto-dialer is approximaly 60 meters (200'). Using HOME MODE is a convenient way to test Sensors and Remotes. In
HOME MODE the auto-dialer will function only as a chime. Press the HOME button on the keypad of the auto- dialer, wait
60 seconds at which time you will hear a beep. Then trigger the wireless sensors. The auto-dialer will receive a signal and a
chime will sound. If you do not hear a chime and the zone is not flashing on the auto-dialer screen, the sensor may be out of
range. Repositioning either the sensor or auto-dialer should fix this problem. Press HOME button again to exit test mode.

MOTION SENSOR

Description of Components
1. Mounting bracket
2. Motion sensor window
3. Battery low / Trigger LED
4. Battery compartment
Installation
• Install 9V battery (included) into the motion sensor (Fig. 4).
• The motion sensor is factory linked to zone 1. When triggered zone 1 will
flash on the auto dialer screen.
2
3
1
4
(Fig. 4)