Ideal Security SK634 Instruction Manual page 5

• Press ARM/DISARM button to confirm.
• You are now ready to program up to 5 emergency telephone numbers. Press the */UP or #/DOWN buttons to select
memory location from 1 to 5. If you select 2 this is where your number will be stored and it will be the 2nd number dialed.
• Enter the telephone number you would like to store, as you would normally dial it in your area (maximum of 32 digits, the
screen will only display the last 16 digits), followed by ARM/DISARM to confirm.
• Repeat steps for the four other numbers you may wish to store.
• DO NOT use 911 as on of the stored telephone numbers.
• Press PROG button eight (8) times to exit the set-up mode.
5. TO DELETE A TELEPHONE NUMBER FROM MEMORY
• Enter password followed by PROG button twice (2).
• "MEMORY" will flash on the auto-dialer screen.
• Press ARM/DISARM button to confirm.
• Press */UP or #/DOWN buttons to select the number you want to delete.
• Press DEL./PAUSE button to delete the number.
• Press the ARM/DISARM button to confirm.
• Press PROG button eight (8) times to exit the set-up mode.
6. PAUSE FUNCTION
The "PAUSE" function can be stored as one digit in the telephone number memory for some dialing operations. Every one
PAUSE in the memory dialing sequence will pause for 3.6 seconds. For example, if you want to store telephone number
514-363-1030 EXTENSION 230 to memory location 2, the operation will be as following:
• Enter password then press PROG button twice (2).
• "MEMORY" will flash on the auto-dialer screen.
• Press ARM/DISARM button to confirm.
• Press */UP or #/DOWN button to select memory location 2.
• Enter 5143631030 press and hold DEL./PAUSE for 2 seconds until the letter F appears on the screen, then enter 230.
• Press ARM/DISARM button to confirm.
• Press PROG button eight (8) times to exit set-up mode.
7. TO PROGRAM AUTO CALL FUNCTION ON/OFF
The auto-dialer has been factory pre-set with the call option ON.
If you do not want the auto dialer to call out change this to OFF:
• Enter password followed by PROG button five (5) times.
• The " " icon will flash on the auto-dialer screen.
• Press ARM/DISARM button to confirm.
• Using */UP or #/DOWN buttons to select call OFF followed by the ARM/DISARM button to confirm.
• Press PROG button five (5) times to exit the set-up mode.
8. TO PROGRAM AUTO DIALING CYCLE (how many times the auto dialer will call the programed numbers).
The auto-dialer has been factory pre-set to auto dial for 1 cycle (When a sensor is triggered the auto dialer will call all stored
numbers 1 time). You can change the number of cycles from 1 to 5 dialing cycles.
• Enter password followed by PROG button six (6) times.
• "CYCLE" will flash on the auto-dialer screen.
• Press ARM/DISARM button to confirm.
• Using */UP and #/DOWN buttons to select number of cycles between 1 and 5 followed
by the ARM/DISARM button to confirm.
• Press PROG button four (4) times to exit set up mode.
9. TO TEST MEMORY DIALING
In standby mode, press and hold the PROG button for at least 3 seconds, you will hear a short beep. Key in the memory
location of the telephone number, i.e. 1 – 5. The telephone number stored in specified memory location will automatically be
dialed. Press the PROG button to stop the dialing. The auto dialer must be connected to a land line in order for this function
to work. If not connected then you will hear 4 short beeps.