Smart Technologies Smart Board Installation Instructions Manual page 15

2. Mark a spot 2¼ inches or 57mm (the distance between the top of
the whiteboard bezel and the bracket screws) down from the wall
mark you made previously (indicating the top of the whiteboard).
3. Place the wall bracket horizontally against the wall (creating an
up-facing slot), with the screw holes on level with the mark made
in step 2 above.
4. Ensure that the wall bracket is level.
You can place a bubble level on top of the wall bracket and then
make adjustments until it is completely level.
5. Insert a pencil into the four screw holes on the wall bracket,
marking their locations on the wall.
Step 2: Attach the wall bracket to the wall
1. If you are mounting the SMART Board on drywall, and if the screws
that will support the wall bracket will not be fastened to a supporting
wall stud, insert the four drywall anchors as described below.
•
Screw the drywall anchors into the wall with the Robertson
screwdriver at the four spots just marked in step 5 above,
keeping the shaft of the anchor very straight so that it enters
the wall at a right angle.
•
Press firmly while turning the screwdriver until the drywall
anchors are snug in the wall.
2. Place the wall bracket horizontally against the wall, with the open
slot facing up.
3. Attach the wall bracket to the wall by inserting the four #8 x 1¼-
inch screws through the holes in the bracket and tightening them
into the wall (or into the drywall anchors you installed above).
bracket on wall, with
open slot facing up
SMART Board Installation Guide 11