Daytime Running Lights - If Equipped; Lights-On Reminder; High/Low Beam Switch; Flash-To-Pass - Dodge 2011 Nitro Owner's Manual

152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To change the brightness of the instrument panel lights,
rotate the center portion of the multifunction lever up or
down.
NOTE: If the driver's door is left open, and the head-
lights or parking lights are left on, a chime will sound.
Daytime Running Lights — If Equipped
The high beam headlights will turn on as Daytime
Running Lights (DRL) and operate at lower intensity
whenever the ignition is ON, the engine is running, the
headlight switch is off, the parking brake is released and
the shift lever is in any position except PARK.
NOTE: The Daytime Running Lights will turn off
automatically when a turn signal is in operation and turn
on again when the turn signal is not operating.

Lights-On Reminder

If the headlights or parking lights are on after the ignition
is turned OFF, a chime will sound when the driver's door
is opened.

High/Low Beam Switch

Push the multifunction lever away from you to switch
the headlights to high beams. Pull the lever toward you
to switch the headlights back to low beams.

Flash-to-Pass

You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward the steer-
ing wheel. This will turn on the high beam headlights
until the lever is released.
Front Fog Lights — If Equipped
The front fog light switch is in the multifunction
lever. To activate the front fog lights, turn on the
parking or low beam headlights and pull out the
end of the lever.
I n f o r m a t i o n P r o v i d e d b y :