Services Button
Services are accessed through the system's Home Screen. The Home Screen shows the system status
with icons to indicate system conditions. It also displays the time and date. The Home Screen displays the
SECURITY and SERVICES buttons. The Home Screen is normally displayed when the system is disarmed. If
it is not currently being displayed, pressing the
Device Management
Setup and control of Z-Wave devices is
accessed by pressing the SERVICES button
and using the Manage Z-Wave Devices Screen.
This screen displays buttons for controlling
various Z-Wave devices and a button to access
the Z-Wave toolbox. (Some Services buttons
may or may not display depending on
options selected by your Installer).
• The SWITCHES button will display
the currently included binary
and multi-level switches.
• The THERMOSTATS button will display
the currently included thermostat devices.
• The DOOR LOCKS button will display
the currently included door lock devices.
• The RULES button will display
the currently programmed Rules
that run Scenes after events.
• The SCENES button will display
currently programmed Scenes
that run device actions.
• The CHECK NETWORK button
tests the connection of all
programmed Z-Wave devices.
• The TOOLBOX button allows access
to the Z-Wave toolbox for setup
of devices (requires entry of the
Master User Code, if enabled).
Toolbox
Z-Wave setup is performed using the Toolbox.
Access the Toolbox using the following steps.
1. From the Manage Z-Wave Devices
Screen, press the TOOLBOX button.
2. Enter the Master User Code. If enabled, only
the Master User Code (or the Installer Code)
can be used to access the Z-Wave Toolbox.
✓ NOTE: Some Z-Wave display screens will
time-out after 30 seconds of inactivity and
the system will return to the Home Screen.
Services Access
button on the Control Panel will display the Home Screen.
The Home Screen
Manage Z-Wave Devices Screen
Master Code Entry Screen
Z-Wave Toolbox Screen
Services
button
Toolbox
button
3
Need help?
Do you have a question about the 2GIG-CNTRL2 and is the answer not in the manual?
Questions and answers