Door Lock User Codes - Go!Control 2GIG-CNTRL2 Operation & User’s Manual

Door Lock User Codes

Each Control Panel user (1-32) can be assigned Door Lock User Codes for controlling one or more
Z-Wave locks. The user's Door Lock User Codes are independent of the user's Control Panel
User Code that arms and disarms the system. Door Lock User Codes cannot be added, removed,
or changed directly from the lock. To add, remove, or change these codes, use the following steps:
1. On the Change Door Locks Settings Screen,
press CODES.
2. Enter the Master User Code to access the Door
Lock User Codes Screen.
• If the user has been disabled, the "disabled
user" icon (a red X) will be displayed.
• Users with access schedules will have the
calendar icon displayed.
• If a user already has a Door Lock User Code set,
the code will be displayed. If a code has not
been set, UNASSIGNED will be displayed.
• If UNKNOWN is displayed, press the refresh
icon to sync with the lock. If there is a code in the
lock for this user, the panel will acquire it. If the lock
doesn't have a code for this user, UNASSIGNED
will be displayed.
• If NOT SUPPORTED is displayed, the user
number is greater than the maximum number
of users allowed by the lock. This user number
cannot be assigned to the lock.
✓ NOTE: Schlage locks only support 19 users
and can be programmed to users 1-19.
✓ NOTE: Kiwkset locks only support 30 users
and can be programmed to users 1-30.
• To remove an existing Door Lock User Code,
press the delete icon next to the user button.
3. Select a user to modify from the Door Locks User
Codes screen.
4. Enter the user's new 4-8 digit Door Lock User
Code, then enter it again to verify the code.
5. A progress screen will be displayed while the
new code is being sent to the door lock.
6. A confi rmation screen will be displayed when
the user's lock code has been set. Press OK.
7. Test the new code by entering it on the door
lock's keypad.
8. If the Auto Disarm option is set, test it by arming
the system then un-locking the door lock with
the lock's keypad. The system should disarm
when the door lock is un-locked.
✓ NOTE: For security, the default internal Master
Code in Yale door locks should always be
changed (at the lock). This code is not related
to any Control Panel or Door Lock User Code.
Basic Operation
User codes button
Door Lock User Code Option
Select user code to change
Door Locks User Codes Screen
Delete code button
Refresh code button
Removing and Refreshing Door Lock User Codes
Door Lock Code Entry Screen
Door Locks User Code Confi rmation Screen
11