Table of Contents
Advertisement
Lights Flash at Unlock
This feature flashes the exterior lamps when the
remote keyless entry transmitter is used to
unlock the vehicle. The lamps will flash for
approximately 20 seconds unless a door is
opened, the ignition is turned to ACCESSORY,
ON, or START or the remote keyless entry
transmitter is used to lock the vehicle. The
following modes are available for selection:
Mode 1: ON
Mode 2: OFF
Before your vehicle was shipped from the factory,
it was programmed to Mode 1. The mode to
which the vehicle was programmed may have
been changed since it left the factory. To program
the vehicle to a different mode, do the following:
1. Enter the Personalization menu following
the instructions listed previously.
2. Scroll to Remote Keyless Options using the
TUNE/SEL knob.
108
3. Press the TUNE/SEL knob to view the modes.
4. Scroll to Lights Flash At Unlock and press
the knob once to select it.
When the mode is turned on, an X will appear
in the box.
The mode you selected is now set. You can either
exit the programming mode by following the
instructions later in this section or program the
next feature available on your vehicle.
Lights Flash at Lock
This feature allows the exterior lamps to flash
once when the remote keyless entry transmitter is
used to lock the vehicle. All doors must be
closed for this feature to work, and the lamps will
not flash if the parking lamps or headlamps
are on. The following modes are available for
selection:
Mode 1: ON
Mode 2: OFF
Advertisement
Table of Contents
