Measuring Procedure - Omega RDXL4SD User Manual

4. MEASURING PROCEDURE

4-1 Type K measurement
1) Power on the meter by pressing the "Power button"
( 3-2, Fig. 1 ) once.
* After the meter is on, pressing the
"Power button" once ( > 2 sec ) will turn off
the meter.
2) Meter default Temp. sensor type is Type K, the display
will show "K" indicator.
The default temperature unit is °C (°F), the method
to change the Temp. unit from °C to °F or °F to °C,
please refer to Chapter 7-5, page 18.
3) Insert the Type K probes into the "T1, T2, T3, T4 input
socket" ( 3-9, Fig. 1).
The LCD will show the 4 channels ( T1, T2, T3, T4 )
temperature value at the same time.
* If the certain channels do not insert the temperature
probes, the relative channel display will show over
range " - - - - - ".
4-2 Type J/T/E/R/S measurement
All the measuring procedures are same as the Type K
(section 4-1 ) except to select the Temp. Sensor type to
" Type J/K/T/E/R/S" by pressing the "Type Button" ( 3-5,
Fig. 1 ) once in sequence until the up LCD display shows the
"J/T/E/R/S" indicator.
7