Solving Problems; Installing Your New Cooker - Baumatic BU54EE User Manual

Solving Problems

If you have a problem with your appliance, check the table below before calling service. You may be able to avoid a
service call by and avoid unnecessary inconvenience and expense.
For cooking problems, refer to Handling Baking Problems.
Problem Causes
Power not turned on or connected
No spark obtained when
Household fuse blown
gas burner knob is
pushed / turned
Circuit breaker tripped
Spark plug is wet or dirty
Burner will not light even Gas supply valve is turned off
though spark can be
burner crown & cap not positioned correctly
seen/heard
Port blockage in ignition area
Digital Clock not set properly
120 min Timer not in "Manual" position
Power not turned on
Oven or grill not working
Household fuse blown
Controls incorrectly set
Circuit breaker tripped
Power not turned on
Household fuse blown
Oven light not working
Circuit breaker tripped
Lamp blown or loose in socket
'Oven heating' indicator No fault if you are using temps > 180 with
lamp does not go OFF conventional or pizza mode selected, this is normal.
Heat escaping through incorrectly
sealed door
Oven not hot enough
Door seal is worn or has moved
Power failure or interruption
Digital timer display
flashing
Household fuse blown or power
supply is off
Unit smoking when first Protective oils being removed
used
Odour on first use of
oven
120 minute timer buzzer Timer not wound sufficiently
not audible
Oven shelf tight Oven shelf not inserted correctly, may be upside
down or back to front
Clock display off Household fuse blown or power
supply is off
NOTE: Only service centers should carry out servicing. Otherwise warranty may be void.
22 Baumatic 540mm Upright Cooker SOLVING PROBLEMS
What to do
Switch on electricity
Check fuses
Check circuit breaker
Dry or clean spark plug
Turn on gas supply
Remove parts and refit carefully
Make sure that ports and ignition area are clean and dry
Refer to digital timer instructions
Refer to 120 min timer instructions
Switch on electricity
Check fuses
Reset controls
Check circuit breaker
Switch on electricity
Check fuses
Check circuit breaker
Replace or tighten globe
It can take a long time (50 - 70 mins or more) for the oven
indicator lamp to go OFF / start cycling.
Check shelves or dishes are not preventing door closing
properly, Check that door is fitted properly after door removal for
cleaning
Replace seal or refit it
Reset time of day
Check fuses, power supply
This is normal
This is normal
Allow 1–4 hours for odour to dissipate (open all windows)
Turn timer knob past 15 minute mark
Then turn to the required number of minutes
Remove shelf and insert as per diagram
Check fuses, power supply

Installing your new cooker

Safety warnings about installation
• The cooker MUST BE installed and serviced only by
an authorised person.
• A certificate of compliance must be supplied by
installer and is to be kept by the customer.
• The packing materials must be removed before you
install the cooker.
• You must follow the installation instructions in this
booklet.
• The surrounding kitchen cabinets MUST BE able to
withstand 85°C. We will not accept responsibility
for damage caused by installation in to kitchen
cabinets which cannot withstand 85°C.
• The appliance must not be installed in a corner. It
must be installed at least 100mm from the side wall.
• The flexible pipe for gas models must have sufficient
loops so the cooker can be moved for service.
• The vents; openings and air spaces MUST NOT be
blocked.
• The anti-tilt floor bracket must be installed to avoid
accidental tipping.
• The stability bolt must be installed to avoid
accidental moving.
• You must not pull the cooker by the door handles.
• Power socket, if provided for gas models, and
electricity isolation switch for electric models and
gas models without a 20A plug, is to be installed
in an accessible position near the cooker (but not
behind cooker).
• If the supply cord or cable is damaged, it must be
replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
Unpacking and installation Instructions
for Installer
Unpacking
• Please check the product and make sure that there
is no damage.
• Read the relevant Installation Sections of this
Manual relating to your Model and type of cooker.
• Confirm that product is compatible with available
electrical / gas supply. Ensure proposed installation
position does not conflict with Installation Sections.
• Check the attachment packing in good condition,
complete accessories.
• Use screw driver to remove Anti-tilt floor bracket,
kick panel and splash back for front control models
screwed onto the rear of the cooker.'
Packaging of
Front control models
Packaging of
Rear control models
Baumatic 540mm Upright Cooker INSTALLING YOUR NEW COOKER 23