Service Mode; Option Code - Thermador PO301 Service Manual

CODE DESCRIPTION
E003 Electronics too hot
E005 Communication error
E009 ROM check error in user interface
E010 Data memory error in user interface
E011 Continuous pushing of single key
E012 Defective User Interface PCB temp.
sensor
E014 ON/OFF key does not work
E032 Continuous pushing of keys
E101/E201 Cvt 1/Cvt 2 Temp. sensor open
E104/E204 Cvt 1/Cvt 2/Temp. sensor shorted
E106/E206 Cvt 1/Cvt 2 Door latch does not lock
E107/E207 Cvt 1/Cvt 2 Door latch does not
unlock
E115/E215 Cvt 1/Cvt 2 Temp. in unlocked cavity
too high
E116 Cvt 1/Cvt 2 Probe error
E118/E218 Cvt 1/Cvt 2 Cooling fan supervision
error
E122 Cvt 1/ Probe sensor temp. too high
E123 Cvt 1/ Probe sensor temp. too low
E124/E224 Cvt 1/Cvt 2 Door switch error
E126/E226 Cvt 1/Cvt 2 Door latch error
E303 Electronics too hot
E309 ROM Check error in control module
E310 Data memory error in control module
CAUSE/ACTION
User interface exceeds
185°F/85°C
Loss of communication
between user interface and
control module. Start-up
error. Check connection of all
communication lines and
control module inputs.
Check user interface
assembly. Inspect touch
PCB.
10 seconds of multiple keys
being pressed.
Refer to Diagram 2/4
Refer to Diagram 2/4
Refer to Diagram 2/4
Refer to Diagram 2/4
Standard probe module is
part of the control module.
Refer to Diagram 1.
Cooling fan speed is too low
or too high. Refer to Diagram
2/4.
Door switch is in undefined
state. Refer to Diagram 2/4.
Door latch is in an undefined
state. Refer to Diagram 2/4.
Control module exceeds
212°F/100°C.
Service Manual for Thermador Professional Series Built-in Wall Ovens
CODE DESCRIPTION
E312 Defective control module PCB temp.
sensor
Table 8 Error codes
6

SERVICE MODE

Only the PODx models with a display have Service Mode capabilities.
1. Set oven mode knob(s) to OFF.
2. Set upper oven temperature knob to 100°.
3. Press SELECT, , and
(P5.1 will appear in the display.)
A button press or change in mode knob will prompt a response.
Service mode will terminate when the upper oven temperature knob is
turned, an oven cavity exceeds 400°, or when idle time exceeds 5
minutes.
7

OPTION CODE

The Option Code on Pro Series ovens is programmed in memory and
will automatically transfer to the User Interface board and PC Control
Module when necessary. Option Codes are provided in Table 9 for
information purposes only.
MODEL OPTION CODE
PO301 0550
POD301 0551
PODC302 1251
POMW301 0550
Table 9 Option codes
CAUSE/ACTION
simultaneously for 5 seconds.
MODEL OPTION CODE
PO302 1050
POD302 1051
POM301 0550
Page 18 of 21