Panasonic WH-MXF09D3E5 Service Manual page 41

11.4.3.1. Selecting The Installation Location
• Allow sufficient space around the remote controller (1) as
shown in the illustration above.
• Install in a place which is away from direct sunlight and high
humidity.
• Install in a flat surface to avoid warping of the remote
controller. If installed to a wall with an uneven surface,
damage to the LCD case or operation problems may result.
• Install in a place where the LCD can be easily seen for
operation. (Standard height from the floor is 1.2 to 1.5
meters.)
• Avoid installing the remote controller cable near refrigerant
pipes or drain pipes, else it will cause electrical shock or fire.
11.4.3.2. Installing The Remote Controller Unit To The Wall
1. Remove the remote controller (1) lower case.
(Insert a flat-tipped screw driver or similar tool 2 to 3 mm
into one of the gaps at the bottom of the case, and twist to
open. Refer to the illustration at right.)
Be careful not to damage the lower case.
2. Do not remove the protective tape which is affixed to the
upper case circuit board when remove the remote
controller lower case.
3. Secure the lower case to an outlet box or wall. Refer to
(A) or (B) instructions below depending on your choice of
cable installation.
4. Be sure to use only the screws provided.
5. Do not over tighten the screws, as it may result in
damage to the lower case.
A. If Remote Controller Cable Is Embedded
1. Embed an outlet box (JIS C 8336) into the wall. Outlet
box may be purchased separately.
Medium-sized square outlet box (obtain locally) Part No.
DS3744 (Panasonic Co., Ltd.) or equivalent.
2. Secure the remote controller lower case to the outlet box
with the two accessory screws (3).
Make sure that the lower case is flat against the wall at
this time, with no bending.
3. Pass the remote controller cable (2) into the box.
4. Route the remote controller cable (2) inside the lower
case through rear feeding-out direction.
5. Insert firmly the connector of remote controller cable (2)
to connector (CON1) in the upper case circuit board.
[Refer to the illustration at below.]
6. Secure the remote controller upper case to the lower
case with the tabs provided.
When the wall is hollow, please be sure to use the sleeve for remote
controller cable to prevent dangers caused by mice biting the cable.
B. If Remote Controller Cable Is Exposed
1. Install the remote controller lower case to the wall with the
two accessory screws (4).
2. Fasten the screws properly until screw head is lower than
the rib and reach the base of remote controller lower case
to ensure they do not damage the PCB inside the remote
controller (1).
3. The feeding-out direction for the remote controller cable
can be either via top, left or right side.
4. Use nipper to cut a notch at the upper case. (Select the
intended feeding-out position)
41