Graco 215-508 User Manual page 3

r
Unplug the electric cord. Open both latches.
Remove the cup.
edge of splash guard drain hole. For fill level when
Pour paint into cup (one quart) or to level of top
painting ceilings, see Painting Ceilings, page 4.
correctly.
Latch the cup, being sure both latches are secured
Open the orange sliding gate wide for walls.
Close sliding gate to obtain a suitable width for
narrow edges of doorways and trim.
8 to 10 inches
(200-250
Hold, the PAINTMASTER
mm) from the surface.
and DOWN strokes:
Make straight, level UP
trigger while moving.
Squeeze and release the
Avoid sudden, jerky move-
ments. Two or three faster
slow one.
strokes are better than one
moving. The paint will
Keep the PAINTMASTER
you apply
it
in one spot
quickly build up and sag if
without moving.
.
MORE THAN 15'
DON'T TIP FORWARD DON'T TIP BACK
WITHOUT SPLASH WITHOUT SPLASH
MORE THAN 30°
GUARD IN PLACE.
PAINT MAY SPILL
GUARD IN PLACE.
OUT IF CUP
I S
FULL1 IF CUP IS FULL1
PAINT MAY SPATTER
OR as close as possible to ceiling when painting ceil-
Hold the PAINTMASTER level when painting walls
ings.
Plug into a electric outlet, using a suitable extension
cord.
Adjust flow to proper output for several-pass
coverage. Close flow control (turn knob fully
clockwise). Trigger ON and gradually turn knob
counterclockwise to obtain proper output. When the
proper output is reached the flow quickly gets
heavier. See page 4 for more details.
motor speeds up. Always close the gate and unplug
Replenish paint supply when pattern stops and
the cord before refilling. Set the motor upside down
on its cap during refilling. Clean paint spatter from
the sliding gate and upper and lower lips of housing
before reassembling. BE SURE both latches are
secure.
307-376
3